The Finest Air Conditioning Options for You Now

Install the outdoor unit of the air conditioner with caution, especially when it comes to a multi-storey building. When choosing a place for an air conditioner, remember that the equipment needs regular technical inspection, so its location should be convenient for a specialist to reach out and perform the whole range of work. But at the same time, the external unit should not interfere with the neighbors, and condensate should not touch the wall of the house. The installation of an external air conditioning unit is carried out on special mounting profiles that are mounted on anchor bolts. In addition to these works, it is necessary to drill a through hole from the room to the street with a diameter of 8 cm, it will be required for laying pipes. With the climatiseur mural you can have the best choices now.

Your Great Options

Installation of the air conditioner indoor unit is the next stage of installation. The indoor unit must not be hung behind curtains and above radiators. It is important to observe the correct distances: at least 10 cm must remain between the outdoor unit and the building wall, as well as between the indoor unit and the ceiling. To install the indoor unit, you need to check the wall for electrical wiring, fix the fixing plate to the wall with dowels and powerful bolts, and make a hole or pave a wall for laying cables and pipes.

Air conditioner connection

We will describe further work in a step-by-step instruction, there is very little left until the first start of the air conditioner.

Air conditioning wiring

The air conditioner must be connected with separate wiring from the shield, it is not recommended to combine its operation with other equipment. Lay stranded wires between the blocks and connect to the terminals using the circuit shown in the instructions for the air conditioner.

Laying air conditioning pipes

Work with copper pipes carefully, avoiding breakage and bending. The error in angular refractions is 1 m. The pipe must be insulated with a polyurethane foam hose, foam rubber will not cope with this task, it has a short service life. Put nuts on the pipes, but do this work carefully. Lay the pipes in the gate and the hole, connect the wiring to them, straighten the hoses and seal the voids with foam or silicone.

Evacuation of the air conditioner

After sealing the connections with a pump, pump air out of the system to remove dust and dirt particles.

Filling the air conditioner

The refrigerant is delivered to the air conditioning system using a cylinder and a pressure gauge necessary to control the pressure. When the system is full, a test mode will start, after which the air conditioner is ready for use. These instructions will help you to observe the correct sequence of actions in the process of installing the air conditioner with your own hands.